1-888-621-3237
Operations
As the user’s hands enter below the beam’ effective range (5 – 15 cm), the beam is reflected back into the sensor receiver and activates the
solenoid valve allowing a single soap application to flow from the dispenser.
Soap Volume Adjustment
No adjustments are required for most settings.Factory default soap volume is 1 ml. The factory setting should be satisfactory for most
installations.To invoke the volume adjustment, press the button below the dispenser and hold it until the LED starts flashing slowly, about five seconds.Press the button again and hold until the LED flashes for approximately 5 seconds and flashing continuously.Place a medium target such as small card board under the dispenser nozzle until the desired volume has been reached. Remove the target to complete setup.
Soap Dispensing Range Adjustments
No adjustments are required for most settings.Factory default range is set at 1 cm. The factory setting should be satisfactory for most
installations.To invoke the sensing range adjustment, press the button below the dispenser and hold it until the LED starts flashing slowly, about five seconds. Press the button again and hold for 5 seconds until the LED flashes continuously.Place a medium target such as small card board below the sensor eye at the desired range until the LED stops flashing. Remove the target to complete setup.
Care & Cleaning
DO NOT USE abrasive or chemical cleaners(including chlorine bleach) to clean dispenser that may dull the luster and attack the special
decorative finishes. Use ONLY mild soap and water, then wipe dry with clean cloth or towel.While cleaning the bathroom tile, protect the
dispenser from any splattering of cleaner. Acids and cleaning fluids will discolor or remove decorative finish.
